Cuda surgical ELITE LLS-9000 Guide De L'utilisateur page 6

Safety
1. Do not expose the charger or power supply to water or liquids; this is not a sealed case.
2. Do not open the charger or power supply case, no user serviceable parts are inside.
3. Do not cover the fan exhaust or obstruct the airflow, this will cause overheating.
Use only the manufacturer's power supply and observe terminal polarity.
4.
5. Place the charger in a cool spot, away from external heat sources
During recalibration the charger may become warm.
Using your Charger
Place the charger on a flat, level surface away from sources of heat and moisture. Plug
the DC connector from the power supply into the back of the charger and connect the
power supply to the mains AC supply using the cable supplied.
Calibration
button
Status window
Charging
Place the battery into the battery bay ensuring that the 5-way connector is fully seated.
The LEDs in the status window will provide status information and the charger will
automatically begin charging.
®
LIT-212 CUDA
(English)
Battery Bay
DC
Connector
Rev. -
Date of Revision:01/20/16
Page 6 of 50