Assembling The Headlight System - Cuda surgical LED-8500II Manuel D'utilisation Et D'entretien

3. ASSEMBLING THE HEADLIGHT SYSTEM

Before continuing remove the protective lens cap.
Insert a fully charged battery into the Battery Holster and ensure it is fully seated down on
the connector at the bottom of the battery cavity.
To attach the power cable from the LED Module to the Battery Holster, insert the push-pull
quick connector of the LED Module into the receptacle on the lead from the Battery Holster
until it clicks in place as shown here. This connection will not come off when positively
engaged. You can rotate the connectors to find the keyway and then press together and
not damage the pins.
The On/Off switch is also the LED intensity control. Simply rotate the knob clockwise or
counter-clockwise to produce the desired light output.
The headlight has an iris to allow adjustment of the beam spot diameter. Rotate the fluted
iris adjustment ring on the headlight clockwise or counterclockwise for the appropriate spot
diameter.
The battery holster is worn on a belt; on the rear side of the holster is a metal belt clip that
slips over and secures to a belt. The power cable secures into the cable clips on the side
and rear of the headband.
To remove the LED Module from the Battery Holster, press the small raised button on the
quick disconnect device located between the LED Module and the Battery Holster and pull
straight out without twisting.
Next, place the headband on your head; you can make size adjustments by turning the
knob on the rear of the headband until it feels comfortable. For more comfort you can
adjust the cross band.
Once the headlight module and cable are connected, the unit is ready for use.
®
LIT-171 CUDA SURGICAL
(English)
Rev. G
Date of Revision:09/01/17
Page 4 of 54