Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION INSTRUCTIONS
WARNING:
1. ENSURE ELECTRICITY IS SWITCHED OFF BEFORE INSTALLATION.
2. Please read following instructions before installing the unit.
3. Prepare all necessary accessories and spare parts (not provided) including a junction box .
4. The Floodlight must be earthed.
5. If the safety shield is damages, you must replace it immediately by tempered glass.
6. Cables and leads should be attached in such a way that only the manufacturer, his service agent
or similarly qualified person can replace them.
MOUNTING
1. Do not mount a surface prone to vibrations.
2. Remove the screw which is for mounting the bracket of the fixture. Remove the bracket.(see fig.1)
3. Mark the hole position to fix the bracket onto the wall. Drill the wall at the marked positions
(screw not supplied) (see fig.2).
4. Screw the fixing bracket to the wall using a suitable screw (see fig.3)
5. Mount the bracket back to the fixture. Adjust the floodlight to the desired position and tighten
the screw of fixing bracket (see fig.4)
6. Connect your mains cable (H05RN-F3G1.0mm
Recommended) to the input lead of our product
2
via the waterproof junction box. Note the Line(-) of the lead (see fig.5). Use a junction box of IP65
or above, tighten the waterproof screw)
7.Switch on the power to make sure if the product works. Adjust the projection angle according to
the condition of use (see fig.6)
Please operate it strictly according to the instructions, in order to avoid damage and injuries.
Do not open the housing. In case of malfunction, please contact your dealer.
EN
2
© Copyright LOTRONIC 2019
Publicité
