Table des Matières
Publicité
Lifebreath Weatherhood
Fixed covered weatherhoods have a built-in bird screen with a 1/4 in (6 mm) mesh to prevent foreign
objects from entering the ductwork.
Installation Notes
The inner and outer liners of the flexible insulated duct must be clamped to the sleeve of the
weatherhoods (as close to the outside as possible) and the appropriate port on the HRV. It is very
important that the fresh air intake line be given special attention to make sure it is well sealed. A good
bead of high quality caulking (preferably acoustical sealant) will seal the inner flexible duct to both the
HRV port and the weatherhood prior to clamping.
The flexible insulated duct that connects the two outside weatherhoods to the HRV should be stretched
tightly and be as short as possible to minimize air flow restrictions.
Twisting or folding the duct will severely restrict airflow.
Hard (rigid) ducting which has been sealed and insulated should be used for runs over 10 ft
(3.3 m). Refer to your local building code.
1/4 in (6 mm)
Screen
Weatherhood Requirements
Check local codes/authority having jurisdiction for acceptance and spacing
requirements for weatherhoods.
Do not locate in garage, attic or crawl space.
Intake:
Should be located upstream (if there are prevailing winds) from the exhaust outlet.
Not near dryer vents, furnace exhaust, driveways, oil fill pipes, gas meters, or garbage
containers.
Exhaust:
Not near a gas meter, electric meter or a walkway where fog or ice could create a hazard.
Attention
Contact your local building authority before installation of the Dual Hood to verify compliance with
local building codes.
Screen
(side view)
Exterior wall
Collar is supplied to
ensure vapor barrier is
100% sealed to wall plate
12 in galvanized
pipe supplied
11
Publicité
Table des Matières
