Table des Matières
Publicité
Installation and Pairing of Repeaters: 99-RX02
The RX02 Repeaters are to be plugged directly into a 120V power outlet
1.
Turn on the main wall control by pressing the ON/OFF button
RX02 with DXPL02 Controls: Press the left and right buttons simultaneously on the main wall
2.
control (
and RESET buttons). The screen will go blank and the wireless symbol
flashing on the bottom right of the display. This indicates that the main control is now in pairing
mode. RX02 with BC04 Control: Press the left and right buttons simultaneously on the main
wall control (
and
the main control is now in pairing mode.
3.
The RX02 Repeater must be powered within 16" of the main wall control for pairing. If an outlet is
not available an extension cord should be used to power the repeater initially for pairing.
4.
Plug the RX02 Repeater into the power outlet. The green light will flash after approximately 12
seconds indicating that the repeater is paired with the main wall control.
5.
Press the ON/OFF button on the main wall control to exit pairing mode and the Repeater may
now be unplugged and moved to its permanent location.
To pair additional RX02 Repeaters with the same wall control, repeat steps
1-5 until all Repeaters have been paired.
When installed in its permanent location, the green LED will remain solid to
indicate the best location and the Repeater can be moved farther if
required. The green LED will flash to indicate it is in a good location. A red
light indicates the Repeater is out of range and needs to be moved closer to
the main wall control.
buttons). The bottom row of 3 LED's will begin flashing. This indicates that
.
will appear
RX02
Repeater
Power
Plug
17
Publicité
Table des Matières
