Technical Data - Meec tools 017978 Mode D'emploi

EN
SYMBOLS
Read the instructions.
Approved in accordance with
the relevant directives.
Recycle discarded product
in accordance with local
regulations.
Use ear protection.
Wear safety glasses or a face
mask.
Double insulation (safety
class II), does not need to be
earthed.
Wear a dust filter mask.

TECHNICAL DATA

Voltage
Output
Speed, no load
Maximum working width
Maximum cutting depth
Sound pressure level, L
Sound power level, L
Vibration
Always use ear protection!
The declared values for vibration and noise,
which have been measured according to a
standardised test method, can be used to
compare different tools with each other and
24
230 V ~ 50 Hz
650 W
18000 rpm
82 mm
2 mm
93,66 dB(A), K=3 dB
pA
104,66 dB(A), K=3 dB
wA
2,589 m/s
for a preliminary assessment of exposure. The
measurement values have been determined in
accordance with EN62841-2-14:2015.
WARNING!
The actual vibration and noise level when
using tools may differ from the specified
maximum value, depending on how the
tool is used and the material. It is therefore
necessary to determine which safety
precautions are required to protect the user,
based on an estimate of exposure in actual
operating conditions (taking into account all
stages of the work cycle, e.g. the time when
the tool is switched off and when it is idling,
in addition to the start-up time).
DESCRIPTION
FIG. 1
1. Power switch
2. Lock button for power switch
3. Adjuster knob for bit depth
4. Ventilation openings
5. Shavings outlet
6. Bag
7. Guide plate
8. Open-end spanner
9. Hex key
USE
2
STARTING / STOPPING
Start and stop the product by pressing and
releasing the power switch. To press the power
switch the power switch lock button must be
pressed first.