Technical Data - Meec tools 017945 Mode D'emploi

Symbols
The following symbols can be of importance
for how you should use your power tool. Make
sure you understand the symbols and their
significance.
Read the instructions.
Use ear protection.
Wear safety glasses or a face
mask.
Wear a dust filter mask.
Double insulation (safety
class II), does not need to be
earthed.
Approved in accordance with
the relevant EU directives.
Recycle as electrical waste.

TECHNICAL DATA

Rated voltage
Max speed, no load
Rebate depth
Planing width
Planing depth
Cord length
Weight
Sound pressure level, L
Sound power level, L
wA
Vibration level, a
h
Always use ear protection!
The declared values for vibration and noise,
which have been measured according to a
standardised test method, can be used to
compare different tools with each other and
for a preliminary assessment of exposure. The
measurement values have been determined in
accordance with EN 62841-2-14:2015.
WARNING!
The actual vibration and noise level when
using tools may differ from the specified
maximum value, depending on how the
tool is used and the material. It is therefore
necessary to determine which safety
precautions are required to protect the user,
based on an estimate of exposure in actual
operating conditions (taking into account all
stages of the work cycle, e.g. the time when
the tool is switched off and when it is idling,
in addition to the start-up time).
230 V ~ 50 Hz
18000 rpm
18 mm
82 mm
3 mm
2 m
3 kg
95.8 dB(A), K=3 dB
pA
106.8 dB(A), K=3 dB
4.366 m/s², K=1.5 m/s²
EN
27