TypeS AC57881 Manuel D'utilisation page 12

Chargeur de batterie et accumulateur 5 a
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OPERATING INSTRUCTIONS CONT.:
FCC Compliance Statement:
5A Battery Charger and Maintainer
Model: AC57881 / Responsible Party: TYPE S
2975 Red Hill Ave., Ste. 100, Costa Mesa, CA 92626 / Tel: 866-294-9244
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received, including interference that may cause
undesired operation.
WARNING: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications or change to this equipment. Such modifications or change could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
vii) Push Mode is designed for charging batteries with voltage
in between 0.5V to 3.75V.
battery is connected and low voltage is detected. You need
to press and hold
Push
flashes alternatively for battery voltage selection. You need
to press
battery will be charged with maximum current of 0.5A until
the voltage is up to 3.75V and it will enter the selected
charge mode for charging onwards.
A Horizon Brands Company
2975 Red Hill Ave., Ste. 100, Costa Mesa, CA 92626
Mon - Fri, 8AM - 5PM (Pacific Time)
Tel: 1-866-294-9244 (English only) | info@typesauto.com
©2021 TYPE S. All rights reserved.
www.typesauto.com
for 3 seconds to enter Push Mode,
lights up and at the same time 6V and 12V icon
once to confirm the voltage selection. The
12
pops up and flashes when
Made in China
CAN ICES-3 (B)/NMB-3(B)

Publicité

Table des Matières
loading

Produits Connexes pour TypeS AC57881

Table des Matières