Automatic Charging - TypeS AC57881 Manuel D'utilisation

OPERATING INSTRUCTIONS CONT.:

AUTOMATIC CHARGING

1. Clean the battery terminals if necessary, always wear safety glasses to
protect your eyes.
2. Verify the voltage and type of battery.
3. Connect the RED
battery terminal. The POSITIVE battery post will be marked with a PLUS
(+) sign. There may also be a
positive battery post.
Connect the BLACK Clamp / ring terminal to the NEGATIVE (-) post of
the battery terminal. The NEGATIVE battery post will be marked with a
MINUS (-) sign. There may be a BLACK plastic protective cover over the
negative battery post.
NOTE: When charging a battery that is mounted on a vehicle, the cables
should be attached in the following order:
- Connect the
battery.
- Connect the BLACK lead to a metal part of the vehicle
chassis. Choose a spot on the chassis that is some distance
away from the battery itself and any fuel lines.
4. Connect the AC power plug of battery
charger into a wall socket. Battery voltage is
auto-detected and charging will be started
automatically. To manually select voltage,
press and hold
NOTE: If a 12V battery with voltage about
3.5-7.6V is connected, the charger will start in 6V Charging
Mode. Press and hold
Charging Mode.
Clamp / ring terminal to the POSITIVE (+) post of the
RED
RED lead to the POSITIVE (+) terminal of the
for 3 seconds.
plastic protective cover over the
for 3 seconds to change to 12V
10