Meec tools 017934 Mode D'emploi page 32

EN
• Do not allow material to dry out on the
surface of the product, this reduces the
shredding capacity.
• Keep the inlet and outlet clean and free
from waste and residue.
• Check that all screw unions are properly
tightened at regular intervals.
• Worn or damaged parts should be
repaired or replaced by qualified
personnel.
• Do not use detergents or solvents that can
damage the plastic parts.
ADJUSTING THE BLADE PLATE
The blade plate must be adjusted regularly for
best results and to avoid damage. The blade
plate must also be adjusted if material often
gets stuck.
1. Turn the knob to adjust the blade plate (A)
anticlockwise until a faint scraping noise
is heard and small aluminium shavings
come out through the outlet.
FIG. 10
FIG. 11
2. The product should then shred normally
again.
IMPORTANT:
Remove dirt and residue after use. Do not rinse
the product with water or use a high-pressure
washer.
Do not use detergents or solvents.
Use a soft brush or cloth when cleaning.
REPLACING BLADE PLATE
1. Undo the 4 screws (A) and open the back
cover.
FIG. 12
2. Take out the blade plate (B) and fit a new
one.
FIG. 13
32
3. Replace the back cover and tighten the
screws.