Electrical Safety - Meec tools 017934 Mode D'emploi

adjusting, maintenance and/or replacing
accessories, and before putting into storage.
Allow the product to cool before checking,
adjusting, maintenance or replacing
accessories, and before putting into storage.
• Be careful when working near the roller
and the fixed blade. The roller can move
even when the motor is not running.
• Be careful when cleaning and/or carrying
out maintenance. Wear safety gloves –
risk of cut injuries.
• Allow the product to cool before putting
into storage.

ELECTRICAL SAFETY

• Check that the rated voltage of the product
corresponds to the mains supply voltage.
• The product must be connected to the
mains supply with a residual current device
with a maximum tripping current of 30 mA.
• Only use an extension cord approved for
outdoor use. Extension cords up to 25 m
must have a cross-sectional wire area of at
least 1.5 mm², and extension cords longer
than 25 m a cross-sectional area of at
least 2.5 mm². If an extension cord is used
on a reel, pull out the full length of cord.
Check the power cord for damage.
• Do not pull the power cord to pull out the
plug. Keep the power cord away from
heat, oil and sharp edges.
SYMBOLS
Read the instructions.
Approved in accordance with
the relevant directives.
Recycle discarded product
in accordance with local
regulations.
Safety class II
Protect the product from
moisture and water.
Use ear protection.
Wear safety gloves.
Disconnect the product from
the mains supply before
making any adjustments or
before servicing.
Keep at a safe distance.
Watch out for ejected objects.
Wear safety glasses.
Indicates value for sound power
94
level.
WARNING: Rotating roller. Keep
your hands and feet at a safe
distance when the machine is
running.
EN
Adjusting the gap
between the roller
and anvil.
29