Overload Protection; Maintenance And Cleaning - Meec tools 017934 Mode D'emploi

IMPORTANT:
Be careful when tilting the product to transport
it on the wheels – the weight is unevenly
balanced.
USE
STARTING / STOPPING
1. Move the rotation selector (A) to position
+.
2. Press the I button on the power switch (B)
to start the motor.
3. Press the O button on the power switch
(B) to stop the motor.
FIG. 8
IMPORTANT:
Incorrect handling can result in material
damage.
Always start the product before feeding in
material. Do not feed in material after the
product has been stopped.
NOTE:
The product has a safety switch to prevent it
starting automatically after a power cut.

OVERLOAD PROTECTION

The product has an overload protection,
which switches off the motor automatically
when overloaded.
Wait at least 1 minute and then try to start
again by first pressing the O button and then
the I button. Follow the instructions below if
the motor does not start.
1. Press the safety switch (A).
2. Move the rotation selector (P) to position –.
3. Press the I button on the switch (C) button
to remove any material blocking the
blades.
FIG. 9
IMPORTANT:
Wear safety gloves.
HOW TO USE
• Put the material to be shredded through
the right side of the opening. It is pulled
automatically into the product because
the blade plate rotates anticlockwise.
• Do not completely fill the opening, this
can cause the product to become blocked.
• Feed wet garden waste intermittently with
branches to avoid the risk of blocking.
• Wet kitchen waste must not be run
through the product and should be
composted.
• Branches with leaves must pass all the
way through and out from the product
before more material is fed in. Check that
the shredded material can drop freely
down into the bin without blocking the
outlet.
• Make sure that the ventilation openings
are not blocked by shredded material.
• The feeding of thick branches opening can
cause the product to become blocked.
• Soft material, such as leaves and shoots,
can block the inlet. Feed it in with the
feeder.
• Check that the material to be shredded
does not contain nails, stones or other
foreign objects, which can seriously
damage the product.

MAINTENANCE AND CLEANING

WARNING!
Switch off the product and pull out the plug
before maintenance and/or cleaning. Always
wear gloves when handling the blade plate.
Keep the product clean for best functionality
and life span.
• Clean the product after it has been used.
EN
31