Maintenance And Storage - Ribiland PRTARTH2 Manuel D'instructions Et D'utilisation

VI. MAINTENANCE AND STORAGE
Before any intervention on product (e.g. cleaning, inspecting or repairing), make sure
that engine has stopped and is cool.
Disconnect the spark plug to prevent accidental starting.
Reminder: Make sure to maintain the machine in good working condition, carry out regular
maintenance of the machine after each use and before storage .Any breach or default of adequate
maintenance reduces the life of the machine and increases the risk of breakdowns and accidents.
To preserve the security system throughout the life of the machine, it is important to perform
maintenance and proper cleaning, DO NOT use non-compliant replacement parts and do NOT
dismantle yourself the machine or change the security features.
WARNING:
• Use protective gloves whenever inspecting, removing and installing the drill.
• Contact with hot muffler may result in a personal injury.
• Do not modify the drill or dismantle the engine
• When replacing parts please use original parts or designated parts.
6.1- Maintenance
Maintenance table
System/components Procedure
fuel leaks, fuel
spillage
fuel tank, air filter,
fuel filter
idle adjusting screw
spark plug
intake air cooling
vent
throttle lever,
ignition switch
Drill
Gear box
screws/nuts/bolts
Before
use
✔
wipe out
✔
inspect/clean
✔
See adjusting
idling speed
clean and readjust
plug gap
Clean
✔
Check operation
✔
replace if
something is
wrong
Grease
✔
Tighten/replace
Every Every
25h 50h
✔
✔
✔
✔
Every Remark
100h
replace, if
necessary
Replace
carburettor, if
necessary
GAP: 0.026
in (0.65 mm)
replace, if
necessary
✔
not adjusting
screws
Page 32 / 52