Ribiland PRTARTH2 Manuel D'instructions Et D'utilisation page 29

4.4.1- Recommended Mixing Ratio
Gasoline 40 : Oil 1
1. This engine is intended to operate on unleaded gasoline.
2. Make sure to use gasoline with a minimum octane number of 90RON
3. If you use a gasoline of a lower octane value than prescribed, there is a danger that the engine
temperature may rise and an engine problem such as piston seizing may consequently occur.
4. Poor quality gasoline or oils may damage sealing rings, fuel lines or fuel tank of the engine.
5. It is recommended to use unleaded gasoline to reduce pollution and thus participate in the
protection of the environment and your health.
4.4.2- How to mix fuel
WARNING - Pay attention to agitation.
1. Measure out the quantities of gasoline and oil to be mixed.
Only mix the amount of fuel you need for the job you intend to do.
2. Put some of the gasoline into a clean, approved fuel container.
3. Pour in all of the oil and agitate well.
4. Pour in the rest of gasoline and agitate again for at least one minute.
As some oils may be difficult to agitate depending on oil ingredients, sufficient agitation is necessary
for the engine to last long. Be careful that, if the agitation is insufficient, there is an increased danger
of early piston seizing due to abnormally lean mixture.
5. Store fuel in a clean, approved container according to local regulations.
6. Put a clear indication on the outside of the container to avoid mixing up with gasoline or other
containers.
7. Indicate the contents on outside of container for easy identification
4.4.3- Fuelling the unit
Note: Ensure that cap and its surroundings are clean. If not, clean as necessary.
1. Unscrew and remove the fuel cap.
Rest the cap on a dustless place.
2. Put fuel into the fuel tank to 80% of the full capacity.
Never fill in tank to its full capacity.
3. Fasten the fuel cap securely and wipe up any fuel spillage around the unit.
WARNING! 1. Never refuel with running engine or with a hot engine.
Stop the engine and let it cool down before refuelling the unit.
At that time, be sure to sufficiently agitate the mixed gasoline in the tank.
2. Select a bare and open ground for fuelling, outdoors or well ventilated. Never
add fuel to the tank in a closed non-ventilated area.
3. Move at least 10 feet (3 meters) away from the fuelling point before starting
the engine.
4.5- Engine
WARNING
It is very dangerous to run this product that mounts broken or loosen parts or lacking any parts.
Before starting engine, make sure that all the parts are installed properly.
Page 29 / 52