Ribiland PRTARTH2 Manuel D'instructions Et D'utilisation page 22

Do NOT spill fuel on the floor or on working area.
Protect the environment
Take used fuel to an authorized collection point or follow the legislation in the
country where the machine is used.
Do not discharge into drains, soil, water or in the environment.
Do not mix it with other waste.
Inspect your machine
It is prohibited to remove or modify guards and safety mechanisms.
Check your machine before turning it on.
Keep guards in place and in working order.
Do not disassemble or modify the protective devices or the machine.
Form a habit of checking to see that keys and adjusting wrenches are removed
from machine before turning it on.
Replace damaged, missing or failed parts before using it.
Make sure all nuts, bolts, screws, fittings, etc. are securely tightened.
Always check the fuel level in the fuel tank.
Never operate your machine when it is in need of repair or is in poor mechanical
condition.
Avoid injury from unexpected accident.
Cutting and crushing hazard! Never touch dangerous parts when the drill
bit is moving.
Always pay full attention to the movement of the drill bit.
Danger! Keep clear of moving parts!
Only use your hands to operate the control levers.
Keep hands, feet and other body parts out of the way of all moving parts.
Warning! Hot surface.
Burning hazard.
Never touch the engine body or exhaust with your bare hands while the engine is
running or immediately after stopping the engine.
Do not expose to or use in weather conditions (ex.: rain, snow ...), moisture.
Do not use in damp or wet areas.
The machine must NOT be sprayed with water (danger due to the presence of
electric current).
Do not operate the unit outdoors when it is raining.
Never leave the machine running unattended
Do not leave the machine unattended when it is running.
Do not leave the machine until it has come to a complete stop and always remove
the spark plug.
Page 22 / 52