Assembly - Delta 50-786 Manuel D'utilisation

UNPACKING AND CLEANING
Carefully unpack the machine and all loose items from the shipping container(s). Remove the rust-preventative oil from
unpainted surfaces using a soft cloth moistened with mineral spirits, paint thinner or denatured alcohol.
NOTICE Do not use highly volatile solvents such as gasoline, naphtha, acetone or lacquer thinner for cleaning your
machine.
fr
AVIS
After cleaning, cover the unpainted surfaces with a good quality household floor paste wax.
sp
AVISO
To reduce the risk of injury, turn unit off and disconnect it from power source before installing and
removing accessories, before adjusting or when making repairs. An accidental start-up can cause injury
ASSEMBLY TOOLS REQUIRED
Cross head screw driver (not supplied)
12 mm and other open-end or socket wrenches
(not supplied)
ASSEMBLINg WHEELS TO BASE
CASTERS (FIg. 1, 2)
1. P lace 3/8" lockwasher (A) onto stud of caster (C).
2. Insert caster stud into threaded hole in the base
— one shown at (D) — and tighten.
3. Tighten base of caster with wrench or needle-nose
pliers, as shown in Figure 2.
4. Repeat for other caster.
FIXED WHEELS (FIg. 3, 4)
1. P lace 3/8" flat washer (B) on a 3/8" x 2-1/2"
(63.5 mm) hex head bolt (F).
2. I nsert hex head bolt through hole (G) in wheel
mount bracket, through center hole (H) of wheel and
through other hole (I) in wheel mount bracket.
3. P lace 3/8" flat washer (B) and 3/8" lock nut (J) onto
hex head bolt (F) and tighten.
NOTE: Do not overtighten lock nut (J) onto the bolt
(F). Be sure wheel is still free to rotate.
4. Repeat for other fixed wheel.
I

ASSEMBLY

FIg. 3
H
g
B
F
ASSEMBLY TIME ESTIMATE
Assembly for this machine takes approximately 1 hour.
A
C
FIg. 1
D
B
j
7
FIg. 2
FIg. 4
F