Operation - Delta 50-786 Manuel D'utilisation

ATTACHINg THE HOSE TO THE
INTAKE PORT (FIG. 31, 32)
Model 50-786 provides two 4" (101.6 mm) dust ports.
If one intake port is unused, seal this open port using the
enclosed dust intake cap.
To install dust intake cap:
Place the open end (JJ) of the intake cap rings around
and on the end of one dust intake port before attaching
the hose to the other. Cover the open intake port with flat
intake cap (KK).
To attach the hose:
Loosely attach the hose clamp (LL) around one end
of the flexible hose (MM). Attach the hose to the dust
intake port (NN) and tighten the hose clamp (LL).
Use the other hose clamp to attach the other end of the
flexible hose to the woodworking machine.
NOTE: Do not operate the dust collector with any dust
intake port (NN) uncovered.
OPERATIONAL CONTROLS AND ADjUSTMENTS
For operator safety, make certain the
dust intake port is covered with the hose before
operating the machine. The rotating fan inside the
blower housing is accessible through the dust intake
port and is hazardous. Always wear proper apparel.
Do not wear jewelry and keep fingers and all foreign
objects out of the dust intake port. Always follow the
safety rules of this manual.
NOTE: The dust collector is shipped with the safety
switch toggle (OO) Fig. 33 removed. The toggle must
be inserted into the dust collector switch and the switch
placed in the "OFF" position before operation.
Remove sticker (PP) covering the switch before inserting
toggle (OO) Fig. 34 into switch (QQ).
STARTINg AND STOPPINg DUST
COLLECTOR (FIg. 33)
Make sure that the switch is in the
"OFF" position before plugging cord into outlet. Do
not touch the plug's metal prongs when unplugging
or plugging in the cord.
The on/off switch (QQ) is located on the side of the
motor. To turn the machine "ON", move the switch up to
the "ON" position. To turn the machine "OFF", move the
switch down to the "OFF" position.
MM

OPERATION

PP
FIg. 33
FIg. 34
13
LL
NN
RR
OO
QQ
OO
jj
KK
FIg. 31
FIg. 32