Display; Remote Control Unit; Battery Installation - Teac SL-D950 Manuel Du Propriétaire

A B C
K J
A Lights in repeat or shuffle mode.
B
Lights when the timer is on.
C
Lights during CD or USB playback.
D When the unit is on, one of these indicators lights
to show the current source.
E Lights during muting.
F
Lights when an FM stereo broadcast is tuned.
G
Shows the digital clock, frequency, elapsed time,
sleep time or preset channels, etc.
H
Lights when an FM RDS broadcast is tuned.
I
Lights when the sleep function is active.
J Lights when the MP3 file is played.
K
Lights in programme mode or preset tuning mode.
12

Display

D
I H G

Remote Control Unit

The provided remote control unit allows the unit to be
operated from a distance.
E
When operating the remote control unit, point it
towards the remote sensor on the front panel of the
unit.
< Even if the remote control unit is operated within
the effective range (5 m), remote control operation
may be impossible if there are any obstacles
F
between the unit and the remote control unit.
< If the remote control unit is operated near other
products which generate infrared rays, or if other
remote control devices using infrared rays are used
near the unit, it may operate incorrectly. Conversely,
the other products may operate incorrectly.

Battery installation

1. Remove the battery compartment cover.
2. Put in the lithium battery (CR2032, 3V).
3. Close the cover.
Battery replacement
If the distance required between the remote control
unit and main unit decreases, the battery is
exhausted. In this case, replace the battery with a
new one.
Precautions concerning batteries
< Do not heat or disassemble batteries and never
dispose of old batteries by throwing them in a fire.
< Attention should be drawn to the environmental
aspects of battery disposal.
CAUTION
Danger of explosion if battery is incorrectly
replaced.
Replace only with the same or equivalent type.