CLAS OE 9000 Mode D'emploi page 18

OE 9000
ELECTRIC & RECHARGEABLE WHEEL LIFTER MAX. 60kg
CLEANING
Do not use pressure washers or high pressure cleaning systems.
Use standard detergent and dry thoroughly after cleaning.
POWER SUPPLY CABLE CONTROL
Check that the cable is in good condition and that there are no bare wires and plugs are intact.
WHEELS CHECK FOR TRANSPORT
Make sure that all the wheels move smoothly on their axis of rotation and the axis of orientation.
Check that the screws are tight
Check that the wheels do not present excessive wear.
EMERGENCY BUTTON CONTROL
Perform the following tests:
1) Operate the lift and test that it stops when you press the emergency button.
2) Repeat the operation for both the operation during up and down operation.
3) Press the emergency button and make sure that the lift doesn't respond to the command of climb
4) Press the emergency button and make sure that the lift doesn't respond to the command of descent.
FORK ROLLERS GREASING
To ensure a smooth rotation of the wheel, plastic rollers must be greased periodically.
Unscrew the locking screws, pull the roller and grease the pivot of the gallows.
Replace the roller and replace the screws making sure they are tight.
TRAPEZOID SCREW AND RUNNERS GREASING
To grease the trapezoid screw and sliding surfaces of the skates perform the following operations:
1) Set the forks at about the halfway point (60-65 cm from the floor)
2) Press the emergency button
3) Make sure the power cord is disconnected
4) Open the cover of the engine compartment and disconnect one of the battery pole
5) Grease the trapezoid screw and sliding surfaces of the skates accessing from the slot on the side of the forks.
Put the oil both above and below the forks, at the points A and B as shown in figure
6) Connect the batteries and close the cover of the engine compartment
7) Release the emergency button
8) Make a few complete runs of the fork to allow the oil to spread evenly.
Use the following grease for bearings AREXON GC300 or equivalent.