Table des Matières
Publicité
2.2. SAFETY AT THE WORKPLACE
a)
Make sure the workplace is orderly and well
lit. A messy or poorly lit workplace may lead to
accidents. Try to anticipate what may happen,
observe what is going on and use common sense
when working with the device.
b)
Upon discovering damage or irregular operation,
immediately switch the device off and report it to
a supervisor without delay.
c)
If there are any doubts as to the correct operation
of the device, contact the manufacturer's support
service.
d)
Only the manufacturer's service point may repair the
device. Do not attempt any repairs independently!
e)
If a fire starts, use solely powder or carbon dioxide
(CO2) fire extinguishers suitable for use on live
devices to put it out.
f)
Children or unauthorised persons are forbidden
from entering a work station. (A distraction may
result in a loss of control over the device).
g)
Use the device in a well-ventilated space.
h)
Do not use the device in a potentially explosive
environment, for example in the presence of
flammable liquids, gases or dust. The device
generates sparks which may ignite dust or fumes.
REMEMBER! When using the device, protect
children and other bystanders.
2.3 PERSONAL SAFETY
a)
The device is not designed to be handled by persons
(including children) with limited mental and sensory
functions or persons lacking relevant experience
and/ or knowledge unless they are supervised by
a person responsible for their safety or they have
received instruction on how to operate the device.
b)
To prevent the device from accidentally switching on,
make sure the switch is on the OFF position before
connecting to a power source.
2.4 SAFE DEVICE USE
a)
Before adjusting, replacing accessories, or storing
the appliance, unplug the appliance from the
power source. This will decrease the possibility of
accidentally switching it on.
b)
When not in use, store in a safe place, away from
children and people not familiar with the device,
who have not read the user manual. The device may
pose a hazard in the hands of inexperienced users.
c)
Maintain the device in a good technical state.
d)
Keep the device out of the reach of children.
e)
Device repair or maintenance should be carried out
by qualified persons, only using original spare parts.
This will ensure safe use.
f)
To ensure the operational integrity of the device, do
not remove factory fitted guards and do not loosen
any screws.
g)
When transporting and handling the device between
the warehouse and the destination, take into account
the occupational health and safety principles for
manual transport operations which apply in the
country where the device will be used.
h)
It is forbidden to move, adjusting and rotating the
device in the course of work
i)
Clean the device regularly to avoid a durable
encrustation of dirt
j)
Do not cover the air intake and outlet.
8
k)
ATTENTION! DANGER TO LIFE! While cleaning, never
immerse the device in water or other liquids.
l)
Do not store heavy, poisonous or corrosive objects in
the device.
m)
Do not use the appliance in unheated rooms and in
locations with high air humidity.
n)
ATTENTION! Do not use any electrical appliances
inside the chamber of the appliance which serves to
store food.
o)
PLEASE NOTE The device contains flammable
substances. Consequently, it should be handed over
for disposal to specialists when its service life is over.
p)
It is not allowed to store potentially explosive
substances in the appliance, e.g.: cans containing
compressed flammable gas.
q)
It is forbidden to place the device near an open
flame, electric stoves, coal stoves or other heat
sources, as well as near direct sunlight. High
temperatures can damage the cooling capacity and
rise the consumption of electricity.
r)
The device must not be connected to the outlet other
than wall-mounted socket, do not use a multiple
outlet adapter or multiple sockets.
s)
If the door is opened too often, there is increased
energy consumption, which could lead to possible
damage..
t)
The power cord connected to the appliance must be
properly grounded and correspond to the technical
details!
u)
The device is not designed for store objects on it.
v)
Do not place heavy objects on the device.
w)
Keep packaging elements and small assembly parts
in a place not available to children.
x)
There is a risk of a child getting stuck inside the
device. Before storing the device withdrawn from
use, it is necessary to dismantle the door and to
leave the shelves in their place, so that children
cannot easily enter the interior..
y)
The device is not a toy. Children should be supervised
so that they will not play with the device.
z)
ATTENTION! The ventilation openings of the
appliance should always be free from blockages
3. USE GUIDELINES
The device, equipped with a compressor, is designed for
cooling wine. The device is intended for indoor home use.
The user is liable for any damage resulting from
nonintended use of the device.
3.1. DEVICE DESCRIPTION
8
3
2
9
1
6
5
4
7
Rev. 19.08.2019
A
B
E
C
D
LIGHT
TEMP
UNLOCK
1.
Handle
2.
Glass door
3.
Hinges
4.
Bottle holder
5.
Seal
6.
Shelf
7.
Leg
8.
Lighting
9.
Controller
A.
Light switch (ON / OFF)
B.
Change of the temperature scale °F/°C
C.
Increasing the temperature
D.
Decreasing the temperature
E.
LCD display
3.2. PREPARING FOR USE
After unpacking the device, check its technical condition.
Set the device in an upright position. In order to level the
device, it is necessary to use adjustable legs. The device
is a free-standing device and is not suitable for durable
furniture integration. It is recommended to install the device
in a place where the ambient temperature is between
23˚-26˚C/72˚-78˚F. If the ambient temperature is higher or
lower than recommended, it may affect the cooler efficiency.
Make sure that the device is upright during transport. For
maximum performance, please install the device in a place
with adequate air circulation and ensure correct electrical
connections. Ensure minimum distance of 19mm from the
side walls, 50mm from the back wall and 100mm from the top
of the device. Do not expose the device to direct sunlight. Do
not place warmed up wine in the cooler. Keep the device away
from hot surfaces. Operate the device on flat, stable, clean,
refractory and dry surfaces out of the reach of children and
people with mental disabilities. Install the device making sure
that constant access to the main plug is ensured.
3.3. DEVICE USE
After connecting the device to the power supply, it is
necessary to set the temperature using the adjustment
buttons (C and D). The cooling system will operate when the
temperature inside the device is higher than the temperature
set on the controller. If the temperature inside the device
falls below the level set on the container, the cooling system
will turn off and will remain disabled until the temperature
rises above the control level.
Backlight:
To turn on the interior lighting, press button A.
Control panel lock:
The panel can be locked. This function prevents unwanted
changes in temperature settings. The lock function will be
activated automatically 12 seconds after the last button has
been pressed on the control panel. To unlock the control
panel, press and hold the increase (C) and decrease (D)
buttons simultaneously for 3 seconds. The device beeps and
the panel flashes to indicate that the control panel is active,
and the settings can be changed.
Rev. 19.08.2019
Setting the temperature:
Cooling temperature can be set by pressing the C or D
buttons on the control panel. The temperature will increase
by 1˚F or 1˚C if you press button C, and will decrease by 1˚F
or 1˚C if you press button D.
Directions for use:
•
When using the device for the first time, or during
restart after a long period of idleness, there may
be a few degrees difference between the selected
temperature and the temperature indicated on the
LCD. This is normal. It is how the device behaves
while starting up. After a few hours of operation,
everything will return to normal.
•
You can place 28 standard bottles in the device.
Bottles may vary in size, therefore, the actual number
of bottles stored may be different. Bottle capacities
are approximately equivalent to capacities of
traditional 750 ml bottles of Bordeaux stored bulk.
3.4. CLEANING AND MAINTENANCE
•
Before each cleaning, adjustment, replacement of
accessories and if the device is not used, it is necessary
to pull out the mains plug and cool the device
completely.
•
Use cleaners without corrosive substances to clean
each surface
•
Use only mild detergents suitable for washing surfaces
which come into contact with food to wash the device.
•
After cleaning the device, all parts should be dried
before reusing it.
•
Store the unit in a dry, cool place, free from moisture
and direct exposure to sunlight.
•
Do not spray the device with a water jet or submerge
it in water.
•
Remember to prevent water from penetrating inside
the device through vents in the housing of the device
•
Regular inspections of the device must be carried out
in terms of its technical efficiency and any damages
•
Use a soft cloth for cleaning.
•
Before first use, remove all elements and clean them
along with the entire device..
•
Do not clean the device with an acidic substance, agents
of medical purposes, thinners, fuel, oils or other chemical
substances because it may damage the device.
Cleaning
•
Disconnect the device from the power source.
•
Clean the inside of the device with warm water and
a neutral detergent. To ensure its efficient operation,
thoroughly clean the rear and bottom part of the
interior of the device. Use soap and water to clean the
door seal.
•
Thoroughly dry all surfaces.
•
Reconnect the device to the power source.
DISPOSING OF USED DEVICES
Do not dispose of this device to municipal waste systems.
Hand it over to electric and electrical device recycling and
collection point. Check the symbol on the product, user
manual and packaging. The plastics used to construct the
device can be recycled in accordance with their markings.
By recycling you are making a significant contribution to the
protection of our environment. Contact local authorities for
information on your local recycling facility
9
Publicité
Table des Matières
