Fiamma F65S Instructions De Montage Et Mode D'emploi page 32

Gebrauchsanweisungen und Ratschläge
DE
FR Instructions et conseils
IT
Avvertenze e suggerimenti
All our awnings 'Made in Italy' and manufactured following high standards.
The awnings are made with precision, but some of the characteristics of the materials
(as little imperfections on paint or linearity of aluminium profiles; little marks or light
deformations of plastic parts), which could be interpreted as defects, derive from the
materials and from the specific work processes, and these characteristics occur even
though Fiamma uses advanced and innovative machine production techniques.
Apart from our strict quality controls, we also have our fabrics continuously controlled
by independent institutes to ensure that the fabric is tear resistant, they can hold the
weight of water, the colours don't fade and it is resistent against atmospheric agents. In
order to enjoy your awning for a long time, even for many years after the purchase
date, we ask you to take note of and follow the simple advices below:
MAINTENANCE INSTRUCTIONS OF FABRIC
Make sure that your awning is completely dry and clean before closing it.
The remaining humidity could cause stains. If however you have no choice but closing
the awning when it is still wet, make sure to open it for drying within 12 hours maximum.
Most of the dirt is superficial and can be removed with clean water and a cloth or a brush.
If the fabric is very dirty, add some light cleaning detergent.
Be aware never to use any aggressive chemical substances and never to clean the fabric
with a high pressure machine. We recommend not to use the awning at a temperature
below 0°C.
· To guarantee a perfect quality, the fabrics are waxed or laminated several times.
During this operation, single coloured pigments could move and thus create small
bright spots in the material, which are only irregularities that are technically inevitable
to avoid, but do not influence the impermeability of the fabric.
The fabric is therefore completely sealed, also in these spots.
· During the production of the material, small creases could form, which especially on
bright fabric in backlight could seem dark. Bright stripes (the so called white crease) are
inevitable with these materials.
· With time the influence of weather could cause change in colour.
· All Fiamma fabrics are soldered on the front bar for a high resistance to water : in case
of rain little drops of water may form near the front bar and this may happen when the
awning is open as well, this doesn't compromise the awning's functionality.
32
EN
ES
Fiammastore
Maintenance instructions
Recomendaciones