Safety Notes; Installation Instructions; Technical Data; Symbol Description - Hansgrohe AXOR Starck 27830 Serie Mode D'emploi / Instructions De Montage

Safety Notes

Gloves should be worn during installation to prevent
crushing and cutting injuries.
The product may only be used for bathing, hygienic
and body cleaning purposes.
Children as well as adults with physical, mental and/
or sensoric impairments must not use this product
without proper supervision. Persons under the influ-
ence of alcohol or drugs are prohibited from using
this product.
Do not allow the streams of the shower touch sensi-
tive body parts (such as your eyes). An adequate
distance must be kept between the shower and you.
The product may not be used as a holding handle. A
separate handle must be installed.
Shower hoses are only suitable for a connection
from the shower to the fitting. Never fit a shut-off
device between the fitting and the hose.

Installation Instructions

• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The pipes and the fixture must be installed, flushed
and tested as per the applicable standards.
• The plumbing codes applicable in the respective
countries must be observed.
• The mesh washer must be insert to protect the over-
head shower against incoming dirt by pipework. In-
coming dirt leads to defects or/and can damage parts
of the shower; such caused faults voids all liability and
guarantee claims.
• Optimal functioning is only guaranteed with the com-
bination of Hansgrohe hand showers and Hansgrohe
shower hoses.
• Where the contractor mounts the product, he should
ensure that the entire area of the wall to which the
mounting plate is to be fitted, is flat (no projecting
joints or tiles sticking out), that the structure of the wall
is suitable for the installation of the product and has
no weak points. The enclosed screws and dowels are
only suitable for concrete. For another wall construc-
tions the manufacturer's indications of the dowel
manufacturer have to be taken into account.
4
English

Technical Data

Operating pressure:
12231000, 27830XXX, 27980000,
27983000 Recommended operating pressure:
0,1 - 0,4 MPa
45722000 Recommended operating pressure:
0,25 - 0,4 MPa
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Thermal disinfection:

Symbol description

Assembly see page 32
Do not use silicone containing acetic acid!
With the excentric washer it is possible to
equalize tolerance of the drilling. (see page
33)
Dimensions (see page 31)

Flow diagram

(see page 31)
Test certificate (see page 35)
Operation (see page 34)
Cleaning (see page 36) and en-
closed brochure
Spare parts (see page 35)
XXX = Colors
000 = chrome plated
820 = brushed nickel
max. 0,6 MPa
max. 60°C
max. 70°C / 4 min