Proper Set-Up Configurations; Gate Assembly - Evenflo Walk-Thru Mode D'emploi

Proper Set-Up Configurations

1
28 - 33 in.
(71.1 - 83.8 cm)
without Frame Extensions
3
38.25 - 43.50 in.
(97.1 - 110.5 cm)
with Long Frame Extension
2
2
33 - 38.25 in.
(83.8 - 97.1 cm)
with Short Frame Extension
4
43.50 - 48 in.
(110.5 - 121.9 cm)
with Short and Long
Frame Extensions
WARNING
DO NOT remove cardboard cover (or plastic tie
beneath it) at this time, or serious injury may result.
1. Measure and record the width of the
opening where you will use the gate.
If the opening is wider than 33 in.
(83.8 cm), refer to page 2 for Proper
Set-Up Configurations.
NOTE: If frame extension is not
required, go to Step 3.
2. If frame extension is required, insert
small extension pins
A
and lower openings in the gate frame
E
, as shown. Push the appropriate
A
frame extension
pins
on the gate frame
extension
A B
plastic caps MUST touch each other
to securely install the frame extension.
NOTE: Frame extension can be
installed on either side of gate.
A E

Gate Assembly

into the upper
E
onto the extension
B
. Make sure the plastic caps
E
and the gate
A
touch each other. The
B
B
3