Protective Measures - Oase ProfiLux LED 110/DMX/02 Notice D'emploi

- GB -
Installation and connection
Installation planning
A
The illustration shows an example of a lighting system. Variations are possible.
• Only connect the LED spotlight to components with compatible connections.
• It is possible to add spotlights to the lighting system if a more powerful switching power pack with additional outputs
is used.
• Switching power pack requirements:
− Electronic switching power pack with DC decoupling between the primary and secondary side.
− Output voltage: 24 V DC
− Residual ripple: Max. 5 %
• Fastening of the LED spotlight:
LED spotlight
ProfiLux LED 110/DMX/02
ProfiPlane LED 110/DMX/02
ProfiLux LED 320/DMX/02
ProfiPlane LED 320/DMX/02
ProfiLux LED 320/DMX/02
ProfiLux LED Spot 1500/DMX/02
ProfiLux LED Flood 1500/DMX/02
• Caption:
ProfiLux LED 110/DMX/01
ProfiPlane LED 110/DMX/01
ProfiLux LED 320/DMX/01
ProfiPlane LED 320/DMX/01
ProfiLux LED Spot 1500/DMX/02
ProfiLux LED Flood 1500/DMX/02
Hybrid extension cable:
3 m length (50728)
7.5 m length (56403)
Connection cable 24 V DC:
1 m length (12762)
3 m length (12552)
7.5 m length (12553)
15 m length (11720)
Connection cable DMX:
1 m length (12368)
3 m length (12369)
10 m length (12372)
20 m length (12373))
Set-up the unit
Attention! Strong optical radiation from LEDs of the risk group 2.
Possible consequences: Damage to eyes.

Protective measures:

• Do not look into the spotlight directly or for a long time when it is on.
• Do not direct the spotlight at persons.
ProfiLux LED 110/DMX/02
How to proceed: 1.
0.
B, C
Using the mounting clamp, screw the spotlight firmly to the sleeve for Komet 10-12 or Komet 10-14.
− To ensure optimum fitting, use the Oase sleeve 10 (article number: 51018).
Loosen the Allen screws on both sides of the spotlight, align the spotlight and tighten both Allen screws.
ProfiPlane LED 110/DMX/02
1. How to proceed:
0.
D, E
Install OASE the ground installation cup.
Place the spotlight into the OASE ground installation cup and fasten with three countersunk head screws.
− When routing the connection cable do not exceed the min. bending radius.
16
37744_04-14_GA_ProfiLED_110_320_16 16
Fastening
To Komet nozzle 10-12 or 10-14
In OASE ground installation cup
With installation bracket to a firm base
In OASE ground installation cup
To Komet nozzle 10-12 or 10-14
With installation bracket to a firm base
11.04.2014 11:53:46