Light Bulb Replacement - Weston PRO-1200 Mode D'emploi

LIGHT BULB REPLACEMENT

WARNING!
Dehydrator, make sure the Dehydrator is OFF and the PLUG IS
REMOVED FROM THE OUTLET/POWER SOURCE!
1. Turn off the Dehydrator Lights. Turn off and disconnect the Dehydrator from
the power outlet.
2. Let the Dehydrator cool. DO NOT attempt to replace a Light Bulb while the
Dehydrator is hot.
3. Remove all of the Racks.
4. Remove the Back Panel of the Dehydrator.
5. Locate the LED Light Fixture that you
wish to replace, and disconnect the wires
from the Light Fixture from the white Wire
Connector on the unit by squeezing together
the two clips on the Wire Connector.
6. Press together the two sides of the Metal
Clip on the Light Fixture to release it from
the body of the Dehydrator and then gently
push the Light Fixture into the Cabinet of the
unit, being sure to have a grip on the wires
connected to the Light Fixture so it does
not drop into the Dehydrator Cabinet. Discard the removed Light Fixture.
7. Insert the replacement Light Fixture into the vacant hole where the old Light
Fixture was by first feeding the wire connected to the Light Fixture first.
8. Line up the Light Fixture with the hole and push it back until the Metal Clips
on the back of the Light Fixture lock into place.
9. Re-connect the Wire Connector attached to the Light Fixture with the Wire
Connector the old Light Fixture was connected to by pressing them together until
they lock.
10. Line the Back Panel of the Dehydrator up and re-install the removed screws
to mount the Back Panel.
14
Before cleaning, assembling or disassembling the
LED Light
Fixture
Wire
Connector
Push
Metal
Clip
Wire
Connector
LED Light
Fixture
Push
Metal
Clip