Programming; Function - Weston PRO-1200 Mode D'emploi

PROGRAMMING

7. TO SET THE TIME: Press the "TIME" Button on the Control Panel one
time. Use the "UP" & "DOWN" Buttons on the right side of the Control Panel to
set the countdown timer hours (23 hour maximum). Press the "TIME" Button
again to switch to minutes. Similarly set the minutes (5 minute increments).
8. TO SET THE TEMPERATURE: Press the "TEMP" Button one time. Use
the "UP" & "DOWN" Buttons to set the temperature (160
minimum, 5 degree increments).
NOTE: Set Temperature is the maximum temperature the Dehydrator could
reach during operation.
9. You do not need to push any other buttons.
automatically start after a brief pause. NOTE: The Dehydrator will start while
you're programming if you delay. Don't worry, this is normal. Just continue
programming as instructed above.

FUNCTION

10. The Digital Display on the Control Panel will continuously cycle while the
unit is operating. It will alternately display: the preset drying time "SET TIME;"
the remaining drying time "TIME REMAINING;" the preset temperature "SET
TEMP;" and the actual current temperature inside the Dehydrator "ACTUAL
TEMP" (measured by the Temperature Sensor on the back wall near the top).
NOTE: The "SET TEMP" is only the highest temperature reached during a
heating cycle. The "SET TEMP" is NOT maintained.
11. The Dehydrator will emit 8 beeps at startup and when the interior
temperature reaches the preset value.
12. The Dehydrator automatically stops (Fan & Heater) when the countdown
timer reaches 0. Unit power will remain on, however.
10
Digital Display
F maximum, 50
o
The Dehydrator will
F
o