Configuring The Wireless Lan; Basic Settings For Wireless Networks - Hama MiMo 300 Express Mode D'emploi

Please enter the following details:
In addition to the access data, you can make the following entries:
MTU stands for Maximal Transfer Unit and specifies the maximum packet size to be transferred. If you are not
sure about this setting, we recommend leaving the standard value set. Values between 512 and 1492 can be
set.
The Connection Type entry sets the dial-in action of your router. You can then select either:
Continuous: The router is always connected to the internet. This connection type is recommended if you have
a flat-rate with no time limit, for example.
Connect on demand: With this connection type, the router does not dial in until it receives a request from a
connected computer, e.g. if you open the internet browser on a computer. The connection is maintained until
the period set under Idle Time Out has passed without activity.
Manual: If you choose the Manual connection type, you can make the connection by clicking Connect, and
close it by clicking Disconnect.
Note! The "Connect as required" setting is recommended for volume or timed rates, so that the
internet connection is disconnected automatically after the period set in the „idle time"
option. Connection costs may be high if permanently connected. Please also note that
closing the browser does not automatically disconnect from the internet. Many programs
send queries to the internet or receive data from it without this being clearly visible. For the
router, these queries are just as valid as opening a browser, for example. If you want to
ensure that there is no active connection to the internet, you should switch off the device or
disconnect it from the modem.
Idle Time Out: Enter the length of time you want to wait before internet connection is cut off when inactive.
Values between 1 and 1000 can be set.
Click OK to confirm your entries. You must then restart the router for the settings to take effect. Click Apply
in the next window to save the settings. The router takes approx. 30 seconds to restart. After the restart the
router is configured so that you can access the internet via the connected computers. You can also edit these
settings manually, by clicking WAN in the menu on the left and then selecting the corresponding connection
type.
3.2 Configuring the Wireless LAN
Wireless LAN is deactivated by default for security reasons. To activate this function, from the start view
which can be accessed by clicking Home, select General Setup and then Wireless in the menu on the left.
Note that activating Wireless LAN without also setting encryption results in a security risk. Select Enable and
then click Apply. Read Basic Settings for Wireless Networks for further instructions!
3.2.1 Basic Settings for Wireless Networks (WLAN)
Select Basic Settings in the menu on the left.
The Mode setting allows you can select the task the router is to perform in the network.
Select the AP (3.2.1.1) access point function if the device is the only access point in your network or if no
bridge level connection is to be made to other access points.
6
User Name
Password
Service Name (this must not always be entered)