Star MAX 615TD Mode D'emploi page 7

6. Remove the slotted, or hex-threaded, plug from the pressure regulator. Invert the plug
and re-install. The letters "LP" should now be visible on the plug. The regulator is now
set for 10" (25.4cm) water column.
7. Set manifold pressure to 10" (25.4cm) water column. A 1/8" pipe plug on the supply pipe
can be removed for attaching a pressure gauge.
CONNECTING GAS SUPPLY LINE
The gas inlet of the griddle is sealed at the factory to prevent entry of dirt. Do not remove this
seal until the actual connection is made to the gas supply line.
CHECKING FOR GAS LEAKS
Soap and water solution or other material acceptable for the purpose shall be used in locating
gas leakage. Matches, candle fl ame, or other sources of ignition shall not be used for this
purpose. Check entire piping system for leaks.
LIGHTING INSTRUCTIONS
When griddle is fi rst lit, it will smoke until the preservation oils and impurities are burned off.
1. Turn off main valve to unit and wait 5 minutes to clear gas.
2. Turn off all knobs and pilot valves.
3. Turn on main valve and light all pilots.
4. Turn burner knobs to desired setting.
5. To turn burners off, turn knobs off.
NOTE: The griddles are equipped with standing pilots and should be lit immediately
after the gas is turned on.
Pilot fl ames can be lit and observed through the front panel view ports. However, best access
for lighting the pilot is from the bottom of the unit just behind the center wall.
LIGHTING INSTRUCTIONS (TCHSD and TSPD SERIES)
1. Turn the control knobs to the "OFF" position.
If the gas valves have been on and gas has escaped through the burners, turn
the burners "OFF" and wait 5 minutes to clear the gas.
2. Turn the control knob to the "PILOT" position, depress and hold the knob while lighting
the pilot. Hold the knob in for 60 seconds or until the pilot stays lit. (Repeat for all burner
sections.)
3. Depress and turn the control knob to the desired temperature.
4. To turn the burners off turn the knob to the "PILOT" position.
5. To turn off all gas turn the knob to the "OFF" position. The pilots must be relit to resume
cooking settings.
PILOT LIGHT REGULATION
Adjust pilot light fl ames as small as possible, but high enough to light burner immediately when
burner valve is turned on high.
ADJUSTING SAFETY PILOTS (SERIES TCHSD and TSPD ONLY)
A manual pilot valve is provided on the left side of the control to adjust the pilot fl ame. Adjust
the pilot fl ame so that it is approximately 3/8 to 1/2" tall and a uniform cone shape.
BURNER ADJUSTMENT (MODELS MD and MDS ONLY)
1. Remove the front panel.
2. Turn burner valve knob to "HI" position.
3. Close the air shutter on the front of the burner to give a soft blue fl ame having luminous
tips and open to a point where the yellow tips disappear and a hard blue fl ame is obtained.
Repeat for all burners.
CAUTION
7