Operation; Oral Cleaning - Silk-n OPTIFLOSS ND -DC01 Mode D'emploi

1. Plug the smaller end of the USB cable
port of the product.
3
2. Plug the larger end of the USB cable into the USB port of the
USB wall adapter
You may also connect the USB cable to a compatible USB
power source (e.g. PC, laptop or powerbank) for charging.
3. Plug the USB wall adapter into a mains socket for charging.
All indicator lights flash when charging starts.
The bottom indicator light stops flashing and stays lit when the
charging level reaches 60 %.
The middle indicator light stops flashing and stays lit when the
charging level reaches 80 %.
All three indicator lights stay lit when the charging level
reaches 98 %.
4. When charging is done, unplug the USB wall adapter from the
mains socket and disconnect the USB cable from the product.

6 Operation

6.1 Oral cleaning

1. Insert a tip into the connection hole
sound when the tip is fully inserted (see step 1 in Fig. B).
Use a standard tip
There are two standard tips (0.6 / 0.8 mm). The one with a
smaller diameter offers higher water pressure.
Use the tongue cleaner tip
cleaning.
Use the orthodontic tip
to-reach places.
Use the plaque remover tip
gums.
2. Rotate the tip so that it is facing a direction convenient for
cleaning (see step 2 in Fig. B). The tip can rotate 360°.
3. Gently pull the water tank
(see step 3 in Fig. B).
4. Hold the product horizontally and flip open the water tank
cover (see Fig. C).
5
5. Fill the water tank with water (not exceeding 40 °C) and close
the cover. Do not overfill the water tank.
.
12
for general teeth and gum cleaning.
8
for tongue scraping and
9
if you have braces, or other hard-
10
to remove plaque around the
11
downwards until it clicks into place
4
into the charging
13
. You will hear a click
1
EN
12