Kohler TROCADERO POWER LITE Instructions D'installation page 5

C. SECURE TOILET
Assemble washers and nuts on exposed T-bolts.
CAUTION: Over-tightening
breakage or chipping.
Hand-tighten nuts, then tighten an additional 1/2-turn with
wrench.
D. ATTACH BOLT COVER
Slide plastic bolt cover (longer tab first) into the side of
toilet. Pull forward to hold in position.
E. CONNECT SUPPLIES
Remove coupling nut from accessory pack packed with
toilet. Carefully bend supply stop tubing to fit. Measure for
required penetration into supply stop. Cut and de-burr
tubing. Place connection hardware onto tubing as shown.
Hand-tighten coupling nut first and then the compression
nut.
F. INSTALL SEAT
Place screws through hinges. Slide a rubber pad over
each screw on the underside of the hinges.
Slide right and left hinges with pads and screws into seat
post holes. When looking from the front of the toilet the
hinge bushings should face in toward each other and slant
toward the back of the toilet.
NOTE: If the right and left hinges are reversed, the seat
and cover will not rotate correctly.
Attach the hinge screw nuts by accessing the underside
of the seat post holes through the tank. Turn the hinge
screw nuts three or four turns for now.
Hold the toilet seat ring and cover together, so the
brackets are aligned. Align the seat ring and cover over
the hinges and bushings. Slide the bushings from the
outside in through the seat and cover brackets.
Align seat on toilet. Tighten hinges with a slotted
screwdriver.
Kohler Co., Kohler, WI U.S.A.
may cause
Valve Shank
Coupling Nut
Hinge
Screw
Nut
5
Fig. #8
Longer Tab
Fig. #9
Washer
Compression
Tubing
Nut
Ferrule
Supply Stop
Fig. #10
Bracket
Bushing
Screw
Hinge
Rubber
Pad
Fig. #11
Nut
Washer
Cover
Seat
A
1007288-2-