Turbo Mode; Footswitch - Buffalo filter PlumeSafe Turbo Manuel De L'opérateur

TURBO MODE

The TURBO button is located on the key pad (Figure 1). The amount of suction is significantly increased
when this button is pressed. To return to NORMAL mode, press the TURBO button again.
FILTER LIFE REMAINING
The exact number of hours and minutes remaining on the ViroSafe® filter (in use) are displayed on the
LCD screen. When the filter's life is consumed, time remaining will indicate that there are 0 hours and
0 minutes remaining. This line will continually flash. When the filter life reaches this point, a new filter
with time remaining should be inserted; however, the suction will still work. When the unit's main power
is turned off or the system is left idle for more than 6 hours, a new filter or a filter with remaining filter
life MUST be inserted into the filter basket to allow the unit's suction to turn back on.
When the filter's life is exhausted the
LCD screen will flash "REPLACE FILTER. "

FOOTSWITCH

A pneumatic footswitch is provided. To activate the footswitch, simply plug the footswitch tubing into the
jack ( ) on the rear panel. The suction can now be switched ON/OFF by depressing the footswitch.
EZ LINK® REMOTE ACTIVATION DEVICE (EZLINK01)
For directions on using the EZ Link®, see instructions accompanying the EZLINK01.
CIRCUIT FUSES
Two 10 amp circuit fuses (8 amp for International systems) are located on the rear panel within the
power entry module. These circuit fuses protect both the system and the operator from damage or injury.
SERVICE
When a service message appears, please contact Buffalo Filter Customer Service for instructions. Below
are some examples of service screens that may appear.
Buffalo Filter Turbo Auto-Sense ™ Operator's Manual: Page 12