Mounting The Packaged Enclosure; Preparation For Mounting - Mettler Toledo IND9D56 Guide D'installation

Chapter 2.0
Installation
This chapter covers:
Mounting the

Mounting the Packaged Enclosure

•
Packaged
Enclosure
Cable Entrances
The IND9D56 is intended for wall mounting. The enclosure should be attached to
•
the wall using the mounting brackets supplied with the device (Figure 2-1, left).
Installing Cables
•
First, the brackets are attached to the enclosure, two at the top and two at the
and Connectors
bottom. The assembly is then mounted to the wall (Figure 2-1, right), as
Closing the
•
described in the following sections.
Enclosure
The IND9D56 is designed to mount on a flat surface, either vertically or
horizontally. Depending on the surface to which it is mounted, fasteners may
include wood screws, concrete wall anchors and dry-wall anchors.

Preparation for Mounting

To prepare the IND9D56 for wall mounting, follow these steps:
•
Mark attachment points
•
Install mounting brackets
•
Mount terminal on brackets
Note: First attach the brackets to the enclosure.
Figure 2-1: Wall Mounting Bracket Kit (left) and Mounting Method (right)