Replacing The Manifold - Tennant ORBIO OS 3 Manuel De L'opérateur

EN OPERATION

REPLACING THE MANIFOLD

Requires service kit AS20044 MANIFOLD
REPLACEMENT
Refer to the Wear Components Indicators panel
on the touch screen display for status of system
wear components. Order a replacement manifold
when the remaining segment of the progress bar
turns yellow. Replace the manifold when the
segment turns red.
Order new manifold
(yellow)
Replace manifold
(red)
1. Disconnect cord from outlet.
FOR SAFETY: When servicing machine
unplug cord from wall outlet.
2. Turn off water.
3.
Dispense either the MultiSurface or
MultiMicro solution into a bucket or a drain
to depressurize the system.
4. Remove front access panel using the access
key.
20
5. Disconnect ribbon cable.
6. Rotate retaining tab counter clockwise to
release the e−module. Loosen with a M7
wrench if needed.
7. With a firm grip pull out e−module from os3.
8. Flex tabs on manifold and separate from
e−cell. Dispose of old manifold.
OS3 DM20036 (1−2018)