Control Elements; Installing The Transmitter - Dometic Waeco PerfectView Accessory VT100WiFi Instructions De Montage Et De Service

Installing the transmitter

5.2

Control elements

No. in fig. 1, page 3
1
2
3
4
5
6
6 Installing the transmitter
6.1 Tools required (fig. 3, page 4)
For installation and assembly, you will need the following tools:
 Drill head set (1)
 Drill (2)
 Screwdriver (3)
 Set of ring or open-ended spanners (4)
 Measuring ruler (5)
 Hammer (6)
 Centre punch (7)
To establish and test the electrical connection, the following tools are required:
 Diode test lamp (8) or voltmeter (9)
 Crimping tool (10)
 Insulating tape (11)
 Cable bushing sleeves (optional)
To secure the transmitter and the cable, you may require additional screws and cable
binders.
22
Meaning
Antenna connection
Operating display; lights up as soon as voltage is applied
Camera connection
Green cable (REVERSE TRIGGER):
Control cable
 for activating the camera
 for activating the motor shutter of the CAM80CM; only
effective if the transmitter is connected to the ignition
plus
Red cable (DC INPUT): Connection to the positive terminal
(+) of the power supply; preferably ignition plus
Black cable (GND): Connection to the negative terminal (–)
of the power supply or earth terminal
VT100WiFi
EN