Dometic Waeco PerfectView Accessory VT100WiFi Instructions De Montage Et De Service page 20

Safety and installation instructions
If you disconnect the negative terminal of the battery, all data stored in the volatile
memories will be lost.
 The following data must be set again, depending on the vehicle equipment options:
– Radio code
– Vehicle clock
– Timer
– On-board computer
– Seat position
You can find instructions for making these settings in the appropriate operating
instructions.
Observe the following installation instructions:
CAUTION!
!
 Secure the parts installed in the vehicle in such a way that they cannot
become loose under any circumstances (sudden braking, accidents) and
cause injuries to the occupants of the vehicle.
 Secure any parts of the system covered by the bodywork in such a manner
that they cannot be come loose or damage other parts and cables or impair
vehicle functions (steering, pedals, etc).
 Always follow the safety instructions of the vehicle manufacturer.
Some work (e.g. on retention systems such as the AIRBAG etc.) may only be
performed by qualified specialists.
NOTICE!
A
 To prevent damage when drilling, make sure there is sufficient space on the
other side for the drill head to come out.
 Deburr all drill holes and treat them with a rust-protection agent.
Observe the following instructions when working with electrical parts:
NOTICE!
A
 When testing the voltage in electrical cables, only use a diode test lamp or a
voltmeter.
Test lamps with an illuminant take up voltages which are too high and which
can damage the vehicle's electronic system.
 When making electrical connections, ensure that:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp edged ducts without protection.
 Insulate all connections.
 Secure the cables against mechanical wear with cable binders or insulating
tape, for example to existing cables.
20
VT100WiFi
EN