Dometic Waeco PerfectView Accessory VT100WiFi Instructions De Montage Et De Service page 25

VT100WiFi
 When laying the cables, make sure:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp-edged ducts without protection (fig. 7, page 5).
 Protect every through-hole made in the bodywork against water penetration, e.g. by
using a cable with a sealant and by spraying the cable and the cable sleeve with
sealant.
I
NOTE
Only start sealing through-holes when you have completed all installation work
on the camera and have laid the required cable lengths.
7.2 Connecting the transmitter electrically (fig. 1, page 3)
A
NOTICE!
Make sure the polarity is correct.
VT100WiFi requires a few seconds to initiate the digital wireless connection. To keep this
start-up time short, you should connect the transmitter to a DC voltage supply. If there is
no continuous operating voltage available, you can connect the transmitter to the
reversing light.
Connecting the transmitter to a continuous operating voltage
➤ Connect the red cable of the transmitter (5) to an active positive cable of the vehicle
battery e.g. terminal 15.
➤ Connect the black cable of the transmitter (6) to the earth terminal on the bodywork.
➤ Connect the green cable of the transmitter (4) depending on the type of camera:
– Camera without motorised protective cover: to an active positive cable of the
vehicle battery (terminal 15, ignition plus)
– Camera with motorised protective cover: to the reversing light.
➤ Connect the camera connector (3) to the camera.
I
NOTE
For Android
Receiving devices with Android
active wireless network connection for accessing the internet. The transmitter
creates a wireless network that does not permit access to the internet.
Therefore internet services cannot be used once the transmitter is being
supplied with power.
The use of telephony and text messages is also restricted.
EN
©
operating systems only:
Connecting the transmitter electrically
©
operating systems automatically use the
25