EUROM Polar 120 Wifi Manual D'instructions page 49

Operation via the app
The Polar can, via Wifi, also be operated with an app. See the separate app
instruction for this.
Additional comments
 When you start the device and opt for a specific function or change function, the
ventilator will work but the compressor will not start immediately: the latter to
protect the internal components. The symbol that belongs to the configured
function blinks on the display, a sign of the 'waiting mode'. This can last 3 to 4
minutes.
 In case of prolonged strong cooling, ice accretion can occur on the interior of the
device. You notice this because the device performs less. To solve this you switch
off the device and give it time to defrost.
 When the required cooling or heating temperature has been attained, the device
will continue ventilating but the compressor discontinues operating.
Water outlet
During cooling and dehumidification, the device extracts water from the air. This
largely evaporates again, but possibly. excess water accumulates in the water
reservoirs. When full, the compressor and motor stop automatically and the "water
tank full" (W.F) light
turns on. In that case,
switch off the air
conditioning and remove
the plug from the socket.
You empty the water
reservoirs by removing
both sealing caps from
the top and bottom water
drainage point (see
pictures) and draining
the reservoirs into a
drain or collecting them
in a container or similar.
Do not forget to replace
the sealing caps on the
drain afterwards! After
this you can start using
the air conditioning
again.
Safety
The device is fitted with an overheating safeguard that switches the unit off if it
overheats. If this should occur, you must remove the plug from the socket and
leave the equipment to cool for at least 30 minutes. Remove the cause of
49