Decoder Functions And Cv Settings; Cv Table For Fx (Mm) - marklin 60972 Mode D'emploi

Decoder functions and CV settings

The following pages have the functions and the CVs presented
in tabular form. These CVs can be given a number of settings
and can be assigned to a number of function buttons.
You will find the CVs and their applications for the fx (MM) and
DCC protocols in separate tables.
CV
Explanation
1
Address 1 (main address)
2 Minimum speed (Vmin)
3
Acceleration delay (AV)
4
Braking delay (BV)
5 Maximum speed (Vmax)
7
Automatic Calibration
8
Decoder reset (default or factory setting)
17
Address 3 (2nd consecutive address)
18
Address 4 (3rd consecutive address)
* () = 6021 Control Unit {} = the values entered are multiplied times "x" (factor)
30
In the mfx protocol, you can set the CVs with ease by means
of the display for the CS 2 (Software Version 4.0 and higher) /
CS 3. You or your dealer may have to install an update on your
60213/60214/60215 Central Station.

CV Table for fx (MM)

Values Default
78
1-255 (1 - 80)*
1-255 (1 - 80)* 4
12
1-255 (1 - 80)*
12
1-255 (1 - 80)*
1-255 (1 - 63)*
180
{x4}*
77
8
254
1-255 (1 - 80)*
253
1-255 (1 - 80)*
.
Notes
Address is always active and is not subject
to CV 49..
Speed at the smallest speed level. Value
must be smaller than Vmax, CV 5.
CV value multiplied by 0.25 gives the time
from complete stop to maximum speed.
CV value multiplied by 0.25 gives the time
from Maximum speed to complete stop.
Speed at the highest speed level. Value must
be greater than CV 2.
Enter Value 77. Value 77 is not stored
continuously.
Value is not written.
Address can be deactivated/activated
subject to CV 49.
Address can be deactivated/activated
subject to CV 49.