Wood's DS-40FS Manuel D'utilisation page 8

Masquer les pouces Voir aussi pour DS-40FS:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4.The humidify and its related position number on the humidity control switch:
CONTROL SWITCH
POSITION NO.
9
7
5
3
1
PRECAUTIONS
1. The operational temperature range for this unit is 5-35 .
2. If the dehumidifier does not start (the operational light does not
illuminate) or the dehumidifier stop operating for unknown reasons,
please check the plug and power supply for poor connection. If the plug
and power supply are in normal condition, wait for 10 minutes and
restart the unit (NOTE: It takes about 10 minutes to reposition). If the unit
still does not start after 10 minutes, please contact your local distributor
service station for repair.
3. When the dehumidifier is in operation the running compressor will
produce heat, resulting in a higher room temperature. This is a normal
condition.
4. The defrost light indicates that the operation of defrost is starting. During
this operation mode, the compressor will be switched off and the air motor
will be turned on.
APPROXIMATE
HUMIDITY SETTING
90﹪
70﹪
50﹪
30 ﹪
10 ﹪
5
USE OF WATER STORAGE TANK
1. Please unplug the stopper before starting the unit.( See Fig.01)
2. When the water tank is full, the water lever indication lamp will illuminate
and the unit will stop working. Please plug the drain hose stopper first
and then take out the water tank to empty the water.(See Fig.02)
3. Install the empty water tank back to its position and unplug the stopper.
Then the unit can continue its operation.
6

Publicité

Table des Matières
loading

Table des Matières