First Troubleshooting - dB Technologies RS16000TR Caractéristiques Techniques

10. FIRST TROUBLESHOOTING

PROBLEM
RS16000TR does not turn on or its
modules are not powered correctly.
One or more already synchronised
radio microphones seem not to
work correctly.
The output microphone signal is
noisy/the reception is disturbed
The screen of HUB800 does not
display the information of the 6
receivers
The dBTechnologies Wireless
Manager software does not detect
the RS16000TR racks correctly
RS16000TR
42
POSSIBLE SOLUTION
• Check the presence of power supply upstream
the system, that the cable with VDE connector is
inserted correctly and that the turn on switch is
set to "ON".
• Check, though the LEDs placed at the back, in the
RPS10 module section, that there are no faults
signalled like short circuits
• Check the battery level on the display and, if
necessary, replace the batteries of the radio
microphones
• Check whether the "MUTE" function is active on
the display of the microphone or of the associated
receiver. If this is the case, disable the function
• Check the gain parameters and OUT LEVEL RX PAR
of the signal on the associated receiver
• If required, synchronise the radio microphone
again with the receiver / turn the device off and
on again
• Check the reception levels and the input
interference in the main page of the receiver
• Adjust the antenna positions
• Use a channel with i5 intermodulation and
synchronise again
• Make sure that all receivers have been set on the
same Country of use and on the same bank. In
this way the home page of HUB800 shows this
information at the top left side of the display
• Check that the wirings and connectors to the PC,
either USB or network type
• Check any ROUTER settings, in case of IP static
assignation check that the requirements of
chapter "REMOTE CONTROL" relevant to the
subnet have been met
English
Cod. 420120285 REV. 1.0