dB Technologies RS16000TR Caractéristiques Techniques page 2

RED CERTIFICATION
This equipment is in conformity with RED directive 2014/53/EU in reference to the following harmonized
standards:
Health EN 62479:2010
Safety EN 62368-1:2014+A11
EMC EN 301 489-1 v2.2.0, EN 301 489-9 v2.1.1, EN 301 789-17 V3.2.0,
EN 55032:2015, EN 55035:2017
Spectrum EN 301 422-1 v2.1.2, EN 300 328 v2.1.1
EN 300422-1 V.2.1.2
EN 301357 V.2.1.1
EN 301489-1 V.2.1.1
EN 301489-9 V.2.1.1
EN 62311 :2008
EN 60065 :2014
EMI CLASSIFICATION
According to the standards EN 55032 and EN 55035 this equipment is designed and suitable to operate in class B
electromagnetic environments.
FCC AND IC CERTIFICATION
RS16000 body – FCC ID:2ADDV-RS16000B
RS16000 body – IC ID:12207A-RS16000B
RS16000 Hand – FCC ID:2ADDV-RS16000H
RS16000 Hand – IC ID:12207A-RS16000H
This equipment has been designed and complies with the safety requirements for portable (<20 cm) RF exposure
in accordance with FCC rule part 2.1091. Installers must ensure that this device must not be co-located or operated
in conjunction with any other antenna or transmitter except in accordance with FCC multi-transmitter product
procedures.
NOTICE
For USA Market:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
RS16000TR
2
Radio Spectrum
EMC
Healty and Safety
Cod. 420120285 REV. 1.0