Firmware Updates - dB Technologies RS16000TR Caractéristiques Techniques

English English

9. FIRMWARE UPDATES

The upgrade of the firmware of the single
receivers can be carried out only by removing
first the fan panel on the back. This operation
must be performed only by expert personnel,
otherwise contact a service centre. It is
possible to access the rack, but it is necessary
to change the audio output mode of the
receivers from "Mic" to "Line", still on the
single RS16000R devices. In this case act
on the selector placed at the back of each
receiver.
To access the back of the 6 RS16000R devices
and upgrade the firmware:
1. operate on a surface with the help of
another person
2. disconnect all external wirings except the
power supply one (the system must be
on)
3. unscrew the fan panel screws
4. an operator extracts the panel just as
much as needed to allow the access of
the second operator (pay attention to the
connectors and power supply wirings of
the fans)
5. Use a PC with installed the
"dBTechnologies Wireless Manager"
software
6. Use a USB cable to connect the RS16000R
receiver and the PC. Once the receiver is
detected, click on UPGRADE on the main
page and follow the instructions (the
upgrade is carried out on 1 receiver at a
time).
7. Once all 6 receivers have been upgraded,
reinsert the fan panel and screw it back to
the case of the touring rack
RS16000TR
NOTE The back of RS16000R is shown
in this figure for information only and
represented without internal wirings and
fan panel for graphical simplification.
Cod. 420120285 REV. 1.0
41