Fitting Instructions For Doors That Open Inwards / Outwards - Abus PR2800 Notice De Montage Et D'utilisation

Fig. 5
1.
2.
1.
2.
Fig. 6
Fig. 8
VI. Fitting instructions for doors that open inwards
Before mounting, please check the setting of the door and adjust it optimally if necessary.
If the door opens outwards, please use the mounting set, accessory PA1018 - page 79.
Before proceeding with the following mounting steps, please check that the PR2800 will fit on
the door panel for bolts that lock with two turns of the key. In narrow niche areas, have the bolt
embedded directly in the masonry, possibly using accessory PWA2700 - page 77.
72
Fig. 5.1
6.
5.
4.
2.
1. loosen
3.
Fig. 7
1.
Fig. 9
Preliminary remarks:
- Make sure the substrate is stable and there are good mounting options. It is particularly
advisable to anchor the lock casing to the masonry and to mount it as close as possible to the
edge of the door, taking the stable substrate into account.
- The bolts should project approx. 10 mm (Fig. 15) from the lock casing.
- Even out the folding thicknesses with plastic washers (Fig. 16).
- Do not allow the lock body to collide with the lock casing on the hinge side (Fig. 17; if
necessary, fit a separate door stopper).
Fitting the lock body
1. Set and mark the position of the lock body on the door panel (Fig. 3+4).
2. Mark the cylinder hole Ø 53-58 mm in the centre of the lock body as shown in Fig. 9. To
check that all the measured dimensions actually fit, place the security door bar on the
floor in front of the markings on the door and lock it out with the key before drilling the
cylinder hole. Make any corrections and then drill the hole from both sides using a
keyhole cutter/saw.
Before fitting the lock body, remove the cover hood corresponding to Fig. 10.
Fig. 10
½ ½
lock body lock body
Ø 53–58 mm
3. Mount the lock body, attach the escutcheon at door exterior (Fig. 11).
4. Position lock body corresponding to Fig. 12.
5. Mark the position of the fastening screws through the mounted lock body. Then turn the lock
body on the cylinder rosette to the vertical position and pre-drill the screw holes
(wood Ø 3.0 mm/metal Ø 3.5 mm). Fasten the lock body in place with screws Ø 4.2 x 22 mm.
Note: With cavity doors, pre-drill Ø 6mm, use supplied bridging cartridge and tighten with
Ø 4 x 35 mm screws corresponding to Fig. 13. Caution! Do not overwind.
Fig. 12
Fig. 11
Fig. 13
30 - 40 mm
Fig. 12a
GB
73