Before Initial Use; Assembling The Device - MAXXMEE AMG26-130 Mode D'emploi

EN
NOTICE – Risk of Damage to
Material and Property
■
Only connect the device to a plug
socket that is properly installed. The
plug socket must also be readily
accessible after connection so that
the connection to the mains can
quickly be isolated. The mains voltage
must match the technical data of the
device.
■
Use only original accessories from the
manufacturer in order to guarantee
that there is no interference that may
prevent the device from working and
to avoid possible damage.
■
Do not operate the device for a long
period of time without any contents to
prevent overheating.
■
Switch off the device and pull the
mains plug out of the plug socket if
an error occurs during operation or
before a thunderstorm.
■
Always pull the mains plug and never
the mains cable to disconnect the
device from the mains power.
■
Do not carry or pull the device by the
connecting cable.
■
Lay the connecting cable in such
a way that it does not become
squashed or bent and does not come
into contact with hot surfaces.
■
Protect the device from heat, naked
flames, direct sunlight, extreme tem-
peratures, moisture and impacts.
■
Store the device in a dry place at tem-
peratures of between 0 and 40°C out
of the reach of children and animals.
■
Never lay or place heavy objects on
the device or the connecting cable.
16
05787_Inlay_de-en-fr-nl_A5_V1.indb 16 05787_Inlay_de-en-fr-nl_A5_V1.indb 16

BEFORE INITIAL USE

There may still be some production
residues on the device. To avoid harmful
effects to your health, clean all accesso-
ries thoroughly before you first use them
(see "Cleaning and Storage").

ASSEMBLING THE DEVICE

Please Note!
■
Pull the mains plug from the plug
socket before swapping inserts to pre-
vent the device from being switched
on accidentally!
Basic Accessories
The following basic accessories are re-
quired to prepare all types of food:
• Motor unit (2)
• Mincing attachment (3)
• Screw conveyor (11)
• Storage bowl (1)
1. Place the motor unit on a kitchen unit
or another dry, flat and stable surface.
2. Insert the mincing attachment into
the mount (16) of the motor unit as
follows:
○ press the release button (14) (Pic-
ture E),
○ hold the mincing attachment so that
the feed chute (17) is horizontal and
directed to the right (i.e. towards
the ON / 0 / R switch (15)),
○ plug the mincing attachment into
the mount,
○ let go of the release button again
and
○ twist the mincing attachment 90° to
the left until the feed chute is verti-
cal and engages (Picture F).
3. Place the screw conveyor with the
long, narrow end first through the
mincing attachment and into the
mount (Picture G).
03.06.2020 09:44:06 03.06.2020 09:44:06