Nuna PIPA lite Mode D'emploi page 23

Head and Body Support
The head and body supports can be used as
necessary, to provide a snug fit for small babies.
The head support straps cannot go through the
same slots as the harness and should only be
used in the top two harness slot positions.
1
- To remove the head support, unfasten the hook
and loop ends behind the seat fabric.
2
- Then, pull the head support straps through the
harness slots.
3
- To remove, the body support, unbuckle the
harness and route the buckle and crotch belt
through the bottom slot of the body support.
4
- The low birth weight pillow (located on the
back of the body support) can be used in the
body support for even smaller babies, but MUST
be removed once a snug fit can be achieved
without it, at approximately 5 kg (11 lbs).
5
- To remove the low birth weight pillow, unfasten
the hook and loop on the back of the body
support and pull out the pillow.
22 PIPA lite series instructions