AVM FRITZ! 600 Mode D'emploi page 6

Connect the FRITZ!Repeater 600 to the Wireless Router
using the Wizard
If your wireless router does not support setup at the touch of a button
(WPS), use the wizard to connect the FRITZ!Repeater with the wireless
router.
1 Establishing a Connection to the Computer
1. Plug the FRITZ!Repeater into an outlet near your wireless router. The
FRITZ!Repeater starts operation.
2. Wait until the LED starts slowly flashing green.
3. Select the Wi-Fi network of your FRITZ!Repeater on the computer, and
start the connection process.
4. Enter the network key of the FRITZ!Repeater. The preconfigured
unique network key is printed on the back of this guide and on the
back of the device housing.
The computer establishes a connection to the FRITZ!Repeater.
10
2
Run the Wizard
1. Open the web browser on your computer and enter
repeater in the address bar.
2. The configuration wizard appears and guides you through setup of the
Wi-Fi connection between the FRITZ!Repeater and your wireless router.
3. Insert the FRITZ!Repeater into an outlet located about halfway between
the wireless router and the wireless devices to be added to the Wi-Fi
network. The FRITZ!Repeater and your wireless router connect once
more.
LED lights up green: the FRITZ!Repeater has a good Wi-Fi connection
and is ready for operation.
LED lights up orange: the FRITZ!Repeater has a weak Wi-Fi
connection. Insert the the FRITZ!Repeater into an outlet closer to the
wireless router.
LED flashing continuously orange: cannot connect via Wi-Fi. Insert the
the FRITZ!Repeater into an outlet closer to the wireless router.
http://fritz.
11