Monogram ZDT165SSLSS Manuel Du Propriétaire page 14

Problem
SANITIZED light does
not illuminate at the
end of the cycle
Noise
A white film on
glassware, dishware
and the interior
Forget to Add a Dish?
Additional items may be added to the dishwasher at any time, ideally items would be added shortly after starting a
wash cycle.
1
Open the door to interrupt the cycle. Pull the door
handle to release the door.
2
Do not open the door all the way until the water spray
action stops. Steam may rise out of the dishwasher.
14
Possible Cause
The door was opened and the
cycle was interrupted during
final rinse
The incoming water
temperature was too low
Normal operating sounds:
Beeping at the end of the cycle
Detergent cup opening
Water entering dishwasher
Motor stops and starts at
various times during cycle
Spray arms start and stop at
various times
Drain pump sounds during
pump out
Drain pump starts and stops
several times during each
drain
Rattling dishes when the spray
arm rotates
Rattling silverware against
door during wash
This problem is likely caused
by a low quality phosphate-
free dishwasher detergent
Troubleshooting Tips
Dishwasher
What To Do
Do not interrupt the cycle by opening the door during the wash
cycle.
Raise the water heater temperature to between 120°F and
150°F.
These are all normal. No action is required.
Make sure dishes are properly loaded. See the Loading
section.
Tall utensils may be placed in the upper rack to avoid bumping
against inner door during wash cycle.
To remove the white film, run your dishes through a dishwasher
cycle with citric acid. Use a WD35X151 citric acid kit found
online. Otherwise, use Finish
your local grocery store.
Pour the citric acid in the detergent cup and close the cover.
Place the filmed but otherwise clean glassware and dishware in
the dishwasher. Leave silverware and other metal items out of
the dishwasher. Turn the dishwasher on and let it run through
a complete cycle without detergent. The glassware, dishware,
and dishwasher should come out film free. Alternatively, a vinegar
rinse may be used. Pour 1 cup of vinegar into dishwasher just
after the detergent cup opens and let the dishwasher complete
its cycle.
This may be repeated several times a year as needed.
The use of a rinse agent such as
may help minimize a repeat build up of film. Also, the use of a
highly rated detergent such as
Dishwashing Detergent will help prevent film build-up.
3
Add additional items.
4
Press START and close the door within 4 seconds to
resume the cycle.
Dishwasher Cleaner found at
®
Finish Jet-Dry Rinse Aid
® ®
Finish Quantum Automatic
® ®