Install The Battery Pack; Remove The Battery Pack; Operation; Examine The Chain Oil - GreenWorks PS24B00 Manuel D'opérateur

• Never use a left-handed (cross-handed) grip, or any
stance that places your body or arm across the chain
line.
• Never stand directly under the limb you are cutting.
• Periodically examine the tightness of the collars during

operation.

7.7

INSTALL THE BATTERY PACK

Figure 5
WARNING
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, know, and do the instructions in the battery and
charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
7.8

REMOVE THE BATTERY PACK

Figure 5
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
8 OPERATION
Remove the battery pack and keep hands clear of the lock
out button when you move the machine.
IMPORTANT
Examine the chain tension before each use.
8.1

EXAMINE THE CHAIN OIL

NOTE
Do not use the machine without sufficient chain oil.
1. Examine the oil level of the machine from the oil
indicator.
2. Add the oil if it is necessary.
8.2

START THE MACHINE

Figure 7
1. Install the battery pack into the machine.
2. Pull the small safety lock button upward with your
thumb.
NOTE
English
3. Press the safety lock button.
4. Press the trigger.
8.3

STOP THE MACHINE

Figure 7.
1. Release the trigger to stop the machine.
8.4

DELIMBING A TREE

Figure 8
Make sure that there is nothing or nobody in the area where
the branches fall.
• Stand opposite the branch you will cut.
• Start to cut the higher branches.
• Then cut the lower branches.
• Cut downwards to prevent the bar from jamming.
8.5

LIMB TREE BRANCHES

Limbing is to remove the branches from a fallen tree.
Figure 9
1. Keep the larger lower branches to hold the log off the
ground.
2. Remove the small limbs in one cut.
3. Limb the branches with tension from the bottom to up.
4. Keep the larger lower branches as a support until the log
is limbed.
9

MAINTENANCE

Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Remove the battery pack from the machine before
maintenance.
9.1

ADJUST THE CHAIN TENSION

Figure 10.13.14
Wear protective gloves if you touch the chain, bar or areas
around the chain.
9
WARNING
CAUTION
CAUTION
WARNING
CAUTION
EN