Description; Purpose; Overview; Safety - GreenWorks ZTF402 Manuel Opérateur

EN
1

DESCRIPTION

1.1

PURPOSE

This garden cart is a garden tool, intended for carrying soil,
grass, etc. in domestic use.
1.2

OVERVIEW

Figure 1 ~ 8.
Bucket
1
Throttle
2
Upper handle
3
Caster wheel
4
Front wheel
5
Bucket handle
6
Bucket release lever
7
Knob
8
Bolt
9
10 Battery pack
11 Battery compartment
2

SAFETY

Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
3

INSTALLATION

3.1

UNPACK THE MACHINE

Make sure that you correctly assemble the machine before
use.
• If the parts have damage, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
12 Battery release button
13 Power switch
14 Speed button
15 Direction button
16 Lock-out button
17 Brake
18 Oil plug
19 Drain plug
20 Air cap
21 Air pin
22 Valve stem
WARNING
WARNING
WARNING
English
3.2

INSTALL THE UPPER HANDLE

Figure 2.
1. Align the holes in the upper handle and the lower handle.
2. Put the bolt through the hole.
3. Tighten the knob onto the bolt.
4. Do the same operation on the other side.
3.3

INSTALL THE BATTERY PACK

Figure 3
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the engine stops before
you install or remove the battery pack.
• Read, know, and do the instructions in the battery and
charger manual.
1. Open the battery door.
2. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
3. Push the battery pack into the battery compartment until
the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
5. Close the battery door.
3.4

REMOVE THE BATTERY PACK

Figure 3.
1. Open the battery door.
2. Push and hold the battery release button.
3. Remove the battery pack from the machine.
4

OPERATION

Hold the handle tightly when you move the machine.
4.1

ADJUST THE SPEED

The machine has a two-speed button.
Figure 4.
1. Push the high speed icon, the machine will work in high
speed.
2. Push the low speed icon, the machine will work in low
speed.
4
WARNING
WARNING
NOTE