Installation Instructions
NOTE: The blocked letters, such as A, shown below, refer to illustrations on
Pages 2 & 4. Match these to the related text pages.
Overall Dimensions A..................................................................................................2
Power Supply B .............................................................................................................2
Junction Box Location D .............................................................................................2
Solid Surface Countertop Installations H and I ................................................ 4-5
Electrical Connection ................................................................................................... 5
IMPORTANT:
INSTALLER:
OWNER:
READ AND SAVE THESE INSTRUCTIONS
OVERALL DIMENSIONS
See Illustration A, Page 2. These dimensions are
overall.
POWER SUPPLY
ELECTRICAL POWER CONNECTION
FOR COOKTOP
Power Supply is dual rated: 240 Volts or 208 Volts,
4 wire, 60 Hz, with the following circuit breaker
requirements: Model NES 730 at 30 Amps; Model
NES 930 at 40 Amps
Connect only to a 4-wire 120/240 or 120/208 volt
ac system. The neutral is required for the operation
of this appliance and an independent ground is
required.
Install a junction box (not supplied), below the
counter top within 3 feet of flexible conduit
(supplied) located at the left rear corner of the
cooktop rough-in box.
Table of Contents
Save these instructions for Local Electrical Inspector's use.
Please leave these Installation Instructions with this unit for the owner.
Please retain these instructions for future reference.
A
B
JUNCTION BOX LOCATION
Plan the installation of the unit so that the location
of the junction box is within 3 feet of the left rear
of the cooktop bottom. It must be accessible
from the front of the cabinet.
PAGE 1
Models: NES 730, NES 930
D